Dell PowerEdge M605 Hardware Owner's Manual page 71
Hide thumbs
Also See for PowerEdge M605:
- Owner's manual (346 pages) ,
- Command reference manual (302 pages) ,
- Getting started (224 pages)
Table of Contents
Advertisement
Table 1-18. Blade Messages (continued)
Message
HyperTransport
error caused a
system reset.
Please check the
system event log
for details.
Invalid
flexAddress for
bus , device ,
function .
Keyboard
controller
failure.
Keyboard failure.
Manufacturing mode
detected.
Causes
HyperTransport
error.
FlexAddress (virtual
MAC) is not supported on
the specified device.
Faulty keyboard controller
(faulty blade board).
Loose or improperly
connected keyboard cable
System is incorrectly
configured.
Corrective Actions
See "Getting Help" on
page 217.
Information only
See "Getting Help" on
page 217.
Ensure that the keyboard is
properly connected. If the
problem persists, replace the
keyboard.
Set the NVRAM_CLR
jumper to "on" and reboot
Figure 7-1,
the blade. See
Figure 7-2,
Figure 7-3 or
Figure 7-4 for the jumper
location.
About Your System
71
Advertisement
Table of Contents
Troubleshooting
