Dell PowerEdge M605 Hardware Owner's Manual page 121

Figure 3-11. Installing and Removing a Memory Module or Memory Module Blank
1 memory module
3 ejectors (2)
5 alignment key
6 Align the memory module's edge connector with the alignment key on the
memory module socket, and insert the memory module in the socket.
NOTE:
install the memory module in the socket in only one way.
7 Press down on the memory module with your thumbs to lock the memory
module into the socket.
When the memory module is properly seated in the socket, the ejectors on
the memory module socket align with the ejectors on the other sockets
that have memory modules installed.
8 Repeat step 5 through step 7 of this procedure to install the remaining
memory modules. See Table 3-5, Table 3-7, or Table 3-8 for sample
memory configurations.
9 PowerEdge 905 systems only - If you removed the system board to access
the memory modules, reinstall the system board.
10 Close the blade. See "Closing the Blade" on page 104.
11 Install the blade. See "Installing a Blade" on page 98.
1
The memory module socket has an alignment key that allows you to
2
4
5
2 edge connector
4 socket
Installing Blade Components
3
121