Ikvm Module; Removing An Ikvm Module; Installing An Ikvm Module; I/O Modules - Dell PowerEdge M605 Hardware Owner's Manual

iKVM Module

Removing an iKVM Module

1 Disconnect the cables attached to the iKVM module.
2 Press in the release latch on the handle and rotate the handle away from
the module front panel. See Figure 4-4.
3 Slide the module out of the enclosure.

Installing an iKVM Module

1 Ensure that the module handle is fully open. See Figure 4-4.
2 Slide the module into the enclosure until the handle contacts the
enclosure.
3 To fully seat the module, close the handle until the release latch snaps into
place.
4 If applicable, connect the keyboard, monitor, and mouse to the module.

I/O Modules

NOTICE:
module or with a filler blank to maintain cooling airflow through the system
enclosure.

Removing an I/O Module

1 If you have not already installed the cable enumerators to make removal
and replacement of the I/O modules easier and faster, install them now.
See the Rack Installation Guide for details.
2 Disconnect the cables attached to the I/O module.
3 Lift the latch on the end of the module's handle and rotate the handle
away from the module. See Figure 4-6.
4 Slide the I/O module out of the enclosure.
5 Install the I/O connector cover.
166
Installing Enclosure Components
If you remove an I/O module, you must either replace it with another I/O