PowerEdge M805 Jumper Settings
Figure 7-2 shows the location of the configuration jumpers on the blade
system board. Table 7-2 lists the jumper settings.
NOTE: Figure 7-2
the right.
Table 7-2. PowerEdge M805 Jumper Settings
PSWD_EN
NVRAM_CLR
PowerEdge M600 Jumper Settings
Figure 7-3 shows the location of the configuration jumpers on the blade
system board. Table 7-3 lists the jumper settings.
NOTE:
Figure 7-3 is oriented with the front end of the blade system board facing to
the right.
204
System Board Information
is oriented with the front end of the blade system board facing to
(default) The password feature is enabled.
The password feature is disabled.
(default) The configuration settings are retained at
system boot.
The configuration settings are cleared at the
next system boot. (If the configuration settings
become corrupted to the point where the
system will not boot, install the jumper and
boot the system. Remove the jumper before
restoring the configuration information.)