Installing A Hard-Drive/Ssd Blank; Shutdown Procedure For Servicing A Hard Drive/Ssd; Configuring The Boot Drive; Removing A 2.5 Inch Hard Drive/Ssd From A 2.5 Inch Hard-Drive/Ssd Carrier - Dell PowerEdge FC630 Owner's Manual

Installing a hard-drive/SSD blank

Prerequisites
1. Ensure that you read the
2. Remove a hard drive/SSD. See
Steps
Insert the hard-drive/SSD blank into the hard-drive/SSD slot until the release latch clicks into place.

Shutdown procedure for servicing a hard drive/SSD

NOTE: This section applies only to situations where the sled must be powered down to service a
hard drive/SSD.
If you need to service a hard drive/SSD, turn off the sled and before removing the hard drive/SSD wait for
30 seconds after the sled's indicator turns off. Otherwise, the hard drive/SSD may not be recognized after
it is reinstalled and the sled is powered on again.

Configuring the boot drive

The drive or device from which the system boots is determined by the boot order specified in the System
Setup.

Removing a 2.5 inch hard drive/SSD from a 2.5 inch hard-drive/SSD carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Keep the #1 Phillips screwdriver ready.
Steps
1. Remove the four screws from the slide rails on the hard-drive/SSD carrier.
2. Slide the hard drive/SSD out of the hard-drive/SSD carrier.
74
Safety instructions.
Removing a hard drive/SSD.
Safety instructions.
Get other manuals https://www.bkmanuals.com