Cable Removal; Installation; Servo Removal; Speed Control - Chrysler Pacifica 2004 Service Manual

Hide thumbs Also See for Pacifica 2004:

Table of Contents

CABLE (Continued)

(6) Remove two nuts attaching mounting bracket

and speed control cable to servo (Fig. 2).

Fig. 2 CABLE TO SERVO MOUNTING

(7) Pull cable away from servo to expose retaining

clip and remove clip attaching cable to servo (Fig. 3).

Fig. 3 CABLE CLIP

(8) Disconnect the vacuum line connection at

intake manifold.

(9) Remove cable.

(1) Route cable.

(2) Slide speed control cable into bracket.

(3) Connect the vacuum line connection at rear of

intake manifold.

(4) Install clip attaching cable to servo (Fig. 3).

(5) Install two nuts attaching mounting bracket

and speed control cable to servo (Fig. 2). Refer to the

torque chart for torque specifications.

(6) Connect electrical connectors and vacuum hose.

(7) Install speed control cable to throttle cam by

sliding clasp into hole (Fig. 1).

(8) Install the servo bracket bolt. Refer to the

torque chart for torque specifications.

(9) Connect the negative battery cable.

(1) Disconnect the negative battery cable.

(2) Remove the servo bracket bolt.

(3) Remove speed control cable from throttle cam

by sliding clasp out hole used for throttle cable (Fig.

Fig. 4 CABLE ROUTING

(4) Remove the throttle cable (with retaining tab)

and then slide cable speed control cable out from

(5) Disconnect electrical connectors and vacuum