8E-8 CRUISE CONTROL SYSTEM
CRUISE MAIN SWITCH INDICATOR LAMP CIRCUIT CHECK
Step
1
Check Circuit for Short.
1) Disconnect connector from cruise control module with
ignition switch OFF.
2) Turn ignition switch ON.
Does cruise main switch indicator lamp turn ON?
2
Check Circuit for Open
1) Check for proper connection to cruise control module at
terminal E132-10.
2) If OK, connect terminal E132-10 to ground.
Does indicator lamp turn ON at ignition switch ON?
3
Lamp Bulb Check
1) Remove cruise main switch from instrument panel.
2) Remove lamp bulb and check it.
Is bulb in good condition?
Fig. for Step 2
Action
Yes
"Lg/W" circuit is
Go to Step 2.
shorted to
ground.
Lamp circuit is
Go to Step 3.
OK.
"B/W" or "Lg/W"
Replace bulb.
circuit is open.
No