SSANGYONG Rodius 2012.07 Manual page 465

02-34
▶Auto Door Lock
1. The door lock system outputs "LOCK" when the vehicle speed maintains over 50 km/h.
However, it doesn't output "LOCK" when all doors are locked or failed.
2. If any of doors is unlocked after outputting "LOCK" in step 1, outputs "LOCK" up to 5 times
(except step (1)) at the interval of one second.
3. If any of doors is unlocked after 5 times of "LOCK" outputs, the door(driver's/passenger's/
rear) is regarded as "FAIL".
4. If the door that was regarded as fail is changed(UNLOCK to LOCK), it will be recognized as a
normal one.
5. If any door is regarded as FAIL, the auto door lock function does not work. (if it is occurred
when the vehicle speed is over 50 km/h, the auto door lock output does not occur even if the
vehicle speed falls below 50 km/h and accelerates again to over 50 km/h.) Nonetheless, the
central door lock function works properly.
6. When the system receives "UNLOCK" signal from a door switch, it outputs "LOCK" signals 5
times. If additional "LOCK" signal from another door switch is detected during the period, the
system outputs five "LOCK" signals 5 times for the switch.
The door lock system outputs "UNLOCK" automatically if the "LOCK" output conditions are
7.
established by this function or the key is cycled(IGN=OFF) (even when there is no "LOCK"
output while the vehicle speed maintains over 50 km/h under lock condition). (If the LOCK
condition is established with the ignition switch ON, the system outputs UNLOCK signal
unconditionally when turning the ignition switch to OFF position.) However, when the ignition
key is turned to "OFF" position, the lock output conditions will be cancelled.
8. The "FAIL" condition of the door will be erased when the ignition key is turned to "OFF"
position.