SSANGYONG Rodius 2012.07 Manual page 271

08-6
2) Leak Test
3) Thermostat
1. Release the pressure in the system by
loosening the pressure cap of the coolant
reservoir slightly. Then, remove the pressure
cap completely.
Never open the cap until the coolant
temperature becomes under 90℃ to
prevent any burn.
2. Add the coolant so that the coolant level is
between MAX and MIN mark on the
coolant auxiliary tank.
3. Connect the tester to the tank filler and
apply pressure (1.4 bar).
4. Check all the coolant hoses, pipes and
connections for leaks when the pressure of
the tester drops, and replace or tighten, if
necessary.
Immerse the thermostat into the water. Heat
the water and check the valve opening
temperature.
Valve opening
temperature
90 ± 2℃