SSANGYONG Rodius 2012.07 Manual page 209

5. Follow the job procedures. If you find a defective component, replace it with new one.
Once disconnected, the fuel pipes between HP pump and fuel rail and between fuel rail and each
injector should be replaced with new ones. The pipes should be tightened tospecified tightening
torques during installation. Over or under torques out of specified range may cause damages and
leaks at connections. Once installed, the pipes have been deformed according to the force
during installation, therefore they are not reusable. The copper washer on injector should be
replaced with new one. The injector holder bolt should be tightened to specified tightening torque
as well. If not, the injection point may be deviated from correct position, and it may cause engine
disorder.
6. Plug the removed components with clean and undamaged sealing caps and store it into the
box to keep the conditions when it was installed.
Fuel filter assembly
Priming pump
8. Check the installed components again and connect the negative battery cable. Start the engine
and check the operating status.
9. With Scan Tool, check if there are current faults and erase the history faults.
7. To supply the fuel to transfer line of HP
pump press the priming pump until it
becomes hard.
Priming pump cap
03-5
2210-01