Pcor Press Cal Date; Temp Cal Date; Firmware; Audit Trail Enable - Honeywell Mini-AT User Manual

Item
No. Item Name
————————————————————————————————————————
120

PCOR PRESS CAL DATE

121

TEMP CAL DATE

122

FIRMWARE

123

AUDIT TRAIL ENABLE

124 REVS PER WAKE-UP
125 PULSER POWER FACTOR This parameter provide a method of assigning a power
www.honeywell.com
106
Page 106
Mini-AT User Guide
Description
Date of the most recent change to PCor CAL ZERO (Item 017).
The date is automatically inserted into item 120 when exiting the
PCor CAL ZERO calibration function
Default = 01-01-98
Date of the most recent change to TCAL ZERO (Item 035). The
date is automatically inserted into item 121 when exiting the TCAL
ZERO calibration function
Default = 01-01-98
This item displays the instrument's operating firmware version
number. The version number reported is automatically inserted
when a firmware file is uploaded into FLASH memory. The Flash
Access Security Jumper must be installed at JB24 pins 5 & 6, prior
to attempting to upload a firmware file.
Obsolete item
This parameter (N) is used to determine the number of meter
revolutions required before a full wake-up is initiated and new
analog measurements are taken. All other meter revolutions will
result in intermediate wake-ups. This function is a carry-over from
the ECAT/Mini as a power conservation feature on fast meters
having fairly constant pressures and temperatures. The
significance of this feature in the Mini-AT is less since the power
drain on the battery is less.
Range - 0 to 15
consumption factor to output pulses. The factor, selected by the
user, permits accurately accounting for battery power, at item 59,
during the transmission of volume pulses. Valid factors are from
1 to 255. The following table list factors for different pulse output
combinations.
Default = 66
Power Factor
Pulse
1-Channel 1-Channel 2-Channel
Width
Form-C
62.5 240
125 240
250 240
500 240
1000 240
Default = 1
Form-A Form-A
66 33
37 19
20 10
10 5
5 3