Installation; Installation By Metrohm; Sample Robot Setting Up - Metrohm OMNIS Sample Robot Pick&Place Product Manual

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

5 Installation

5.1

Installation by Metrohm

5.2

Sample robot setting up

NOTICE
Installation of the products
As a basic rule, the installation of the system and of the new products
and modules is handled by trained and instructed specialists from the
Metrohm Company and/or its representative.
The product has been developed for operation indoors and may not be
used in explosive environments.
Place the instrument in a location of the laboratory which is suitable for
operation and provides protection against corrosive atmosphere and con-
tamination by chemicals.
The sample robot needs a horizontal and plane table that is stable and
free of vibrations for a precise mode of operation. The work surface may
not bend under a load of 60 kg.
Observe the dimensions and weights of the individual products and mod-
ules that are part of the complete system. You will find this information in
the "Technical specifications" section.
Protect the product against excessive temperature fluctuations and direct
sunlight.
The power cord has to be accessible while operating and must not be
replaced by an impermissible cable.
Installation
￭￭￭￭￭￭￭￭
35