Intended Use; Residual Risks; General Dangers At The Workplace - Metrohm OMNIS Sample Robot Pick&Place Product Manual

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2.4

Intended use

2.5

Residual risks

2.5.1

General dangers at the workplace

– Warning of cut injuries from pieces of broken glass and/or sharp
edges
– Warning of risk of injury by laser radiation
– Warning of dangerous optical radiation
Metrohm products are used for the analysis and handling of chemicals.
Usage therefore requires the user to have basic knowledge and experience
in handling chemicals. Knowledge regarding the application of fire preven-
tion measures prescribed for laboratories is also mandatory.
Adherence to this technical documentation and compliance with the
maintenance specifications make up an important part of intended use.
Any utilization in excess of or deviating from the intended use is regarded
as misuse.
Specifications regarding the operating values and limit values of individual
products are contained in the "Technical specifications" section, if relevant.
Exceeding and/or not observing the mentioned limit values during opera-
tion puts people and components at risk. The manufacturer assumes no
liability for damage due to non-observance of these limit values.
The EU declaration of conformity loses its validity if modifications are car-
ried out on the products and/or the components.
Generally, the regulations and provisions of the regulatory institutions and
authorities in the field of work apply.
The instructions regarding the following areas have to be followed when
using the products:
Work safety
￭
Handling mechanical installations
￭
Handling electricity
￭
Handling hazardous and environmentally damaging substances
￭
Handling hazardous and environmentally damaging liquids
￭
Disposing hazardous and environmentally damaging substances
￭
If they are not followed, this may result in:
Safety
￭￭￭￭￭￭￭￭
9