Load Parameters From Keypad; Transfer Of Parameters Between Drives - gefran ADV200 Series Quick Start Up Manual, Specification And Installation

If an error occurs during transfer, the following message is displayed:
T+
Message
Save par failed
Code:
Press ESC to exit
The code XX indicates the type of error, see
To exit from the error message, press the ESC key.

6.8.3 Load parameters from keypad

Menu 04 DRIVE CONFIG, parameter 04.20 Load par from keypad, PAR : 592.
Is used to transfer the parameters from the selected memory of the keypad to the
drive.
T+
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
To start the operation, press the E key. During transfer, a bar is displayed which
indicates progress of the operation.
Instead of the letter X, the number of the currently selected keypad memory is
displayed.
At the end of transfer, if this has been completed successfully, the "Done" caption
is displayed for a few seconds with subsequent return to the initial page.
If an error occurs during transfer, the following message is displayed:
T+
Message
Load par failed
Code:
Press ESC to exit
The code XX indicates the type of error, see
To exit from the error message, press the ESC key.

6.8.4 Transfer of parameters between drives

Transfer the parameters of the source drive to the keypad memory as indicated in
paragraph
be saved and proceed as indicated in paragraph 6.8.3.
To prevent possible damage to equipment, it is advisable to disconnect and connect the
keypad with the drive OFF.
Pour éviter tout endommagement possible des appareils, il est conseillé de débrancher et de
Caution
brancher le pavé de commande une fois le drive éteint.
74
T- EN LOC ILim n:0 AL
0 1
XX
T - EN LOC ILim n:0 AL
T- EN LOC ILim n:0 AL
0 1
XX
6.8.2, then connect the keypad to the drive on which the new setting is to
ADV200 • Quick start up guide
paragraph
T+ T- EN LOC ILim n:0
X 2
0 4 . 1 8 PA R : 5 9 2
Load par from keypad
Press E to execute
paragraph
8.2.
AL T+ T- EN LOC
0 4 . 1 8 PA R :
E
DRIVE <-- K2006 X
8.2.
ILim n:0 AL
5 9 2