gefran ADV200 Series Quick Start Up Manual, Specification And Installation page 95

Step 6 - Setting the maximum speed reference value (Set max speed)
This step is used to define the maximum motor speed value that can be reached
with each single reference signal (analog or digital).
T+ T- EN LOC ILim n:0 AL
STARTUP WIZARD
Set max speed ?
E=Yes Down=Next
After setting the speed, proceed to Step 7 to set the acceleration and deceleration
ramp parameters.
Step 7 - Setting ramp parameters (Set ramps)
Set the acceleration and deceleration times for the profile of ramp 0 :
T+ T- EN LOC ILim n:0 AL
STARTUP WIZARD
Set ramps ?
E=Yes Down=Next
Note !
After setting the acceleration and deceleration ramps, the parameters that have been set manually and
calculated using the self-tuning procedures can be saved permanently in a non-volatile flash memory.
To save the parameters proceed to Step 8.
Step 8 - Saving parameters (Save parameters)
To save the new parameter settings, so that they are maintained also after power-
off, proceed as follows:
T+ T- EN LOC ILim n:0 AL
STARTUP WIZARD
E
Save parameters ?
E=Yes Down=Next
T+ T- EN LOC ILim n:0
S E Q . 0 1 PA R : 6 8 0
E
Full scale speed
1500
+
rpm
Def: +1500
PAR: 700
T+ T- EN LOC ILim n:0
S E Q . 0 1 PA R : 7 0 0
E
Acceleration time 0
10.00
+
s
Def: +10.00
T+ T- EN LOC ILim n:0 AL
S E Q . 0 1 PA R : 5 5 0
E
Save parameters
Press E to execute
ADV200 • Quick start up guide
AL T+ T- EN LOC ILim
S E Q . 0 1 PA R :
E
Full scale speed
000001500
+
Def: +1500
T
PAR: 700
AL T+ T- EN LOC
S E Q . 0 2 PA R :
Deceleration time 0
10.00
+
Def: +10.00
T+ T- EN LOC ILim n:0 AL T+
S E Q . 0 1 PA R : 5 5 0 S E Q . 0 1
Save parameters Save parameters
In progress Done
n:0 AL T+ T- EN
E
6 8 0 S E Q . 0 1
Full scale speed
000000750
+
rpm
Def: +1500
ILim n:0 AL
7 0 2
s
T- EN LOC ILim n:0 AL T+ T-
PA R : 5 5 0
STARTUP WIZARD
End of sequence !
Up=Back
LOC ILim n:0 AL
PA R : 6 8 0
rpm
EN LOC ILim n:0 AL
Down=Exit
95