Startup Wizard; Startup Wizard For Asynchronous Motors - gefran ADV200 Series Quick Start Up Manual, Specification And Installation

7.1 Startup Wizard

7.1.1 Startup Wizard for Asynchronous Motors

Introduction
The ADV200 can operate with regulation modes : V/f control (Voltage/Frequency) ,
Flux vector OL (open loop) and Flux vector CL (field-oriented control, closed loop).
Menu 04 DRIVE CONFIG, parameter 04.2 Regulation mode, PAR: 552, default=V/f
control.
Start-up in one mode is valid also for the other regulation modes.
The startup wizard is a guided procedure used for quick start-up of the drive that
helps to set the main parameters.
It consists of a series of questions relating to the various sequences for entering
and calculating the parameters necessary for correct drive operation.
The order of these sequences is as follows:
● Basic connections
● Setting motor parameters
● Self-tuning with rotating motor
● Self-tuning with motor at stand-still or coupled to the load
● Setting the maximum speed reference value
● Setting ramp parameters
● Saving parameters
● Speed regulation setting
● Setting the motor in Flux vector OL control mode
The format of the function selection page is as follows:
T+
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
Pressing the E key, the function to be programmed is accessed.
Press the ▼ (Down) key to move to the next function skipping the current function.
Press the ▲ key to return to the previous function.
To terminate the sequence of functions and return to the menu, press the ESC key.
The end of the start-up sequence is indicated with the page:
T+
STARTUP WIZARD
End of se q uence !
U p =Back
Press the ▼(Down) key to exit the sequence and return to the menu.
Note !
In the procedures described below, the settings have been made using the ADV2075 drive and a 10 Hp
(7.36 kW) asynchronous motor.
78
T - EN LOC ILim n:0 AL
T- EN LOC ILim n:0 AL
Down=Next
ADV200 • Quick start up guide
T+ T- EN LOC ILim n:0 AL
STARTUP WIZARD
Set motor data ?
E=Yes Down=Next
step 1
See
step 2
See
step 3A
See
step 3B
See
step 4
See
step 5
See
step 6
See
step 7
See
step 8
See