Sbus<N>:Flexray:trigger:event:bss:id - Keysight Technologies InfiniiVision 4000 X Series Programmer's Manual

:SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID
Command Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID <frame_id>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
The :SBUS<N>:FLEXray:TRIGger:EVENt:BSS:ID command sets the frame ID used
by the Byte Start Sequence (BSS) event trigger. This setting is only valid if the
trigger mode is EVENt and the EVENt:TYPE is BSS.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID?
The :SBUS<n>:FLEXray:TRIGger:EVENt:BSS:ID? query returns the current frame ID
setting for the Byte Start Sequence (BSS) event trigger setup.
Return Format
<frame_id><NL>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
See Also •
•
•
•
•
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1610)
"Introduction to :TRIGger Commands"
":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE"
":SBUS<n>:FLEXray:TRIGger:EVENt:AUToset"
":TRIGger:MODE" on page 1308
":SBUS<n>:FLEXray:TRIGger"
on page 1295
on page 938
on page 936
on page 934
31
:SBUS<n> Commands
937