Mounting The Device On To The Rack; Checking The Accessories Required For Mounting - Avaya Scopia Elite 6000 MCU Series Rack Mounting Manual

Mounting the Device on to the Rack

To mount the device, perform these tasks in the order listed:
Related links
Setting up the Device

Checking the Accessories Required for Mounting

Marking the location of the rail-fixing cage nuts
Marking the location of the MCU-fixing cage nuts
Removing the Cage Nut Screws
Mounting the rail-fixing cage nuts
Mounting the MCU-fixing Cage Nuts
Mounting the Outer Rails on to the Rack
Mounting the Device on to the Outer Rails
Checking the Accessories Required for Mounting
Check you have the accessories necessary for mounting the MCU (see
required for mounting
• 1 left rail labeled L-FRONT at one end, and L-REAR at the other end
• 12 cage nuts (M6) and 12 hexagon socket cap screws (M6x10, DIN 7984)
• Allen wrench (4mm diameter)
Important:
The rails (and 8 of the cage nuts and screws required to attach the rails) are not used for shelf
mounting.
Related links
Mounting the Device on to the Rack
January 2017
on page 14
on page 19
on page 19
on page 20
on page 20
on page 24
on page 17):
Figure 6: Accessories required for mounting
on page 17
Rack Mounting Guide for Avaya Scopia Elite 6000 MCU
Comments on this document? infodev@avaya.com
Mounting the Device on to the Rack
on page 17
on page 18
on page 18
Figure 6: Accessories
17