Avaya Scopia Elite 6000 MCU Series Rack Mounting Manual page 31

Table of Contents

4. Verify the device is ready for use by creating a videoconference:

a. From an endpoint dial the MCU IP address.

The MCU Auto-Attendant service plays the video and audio prompts.

b. Press 0 to create a new videoconference.

c. At the prompt, enter the meeting ID followed by #.

The MCU creates the conference and opens the Conference window.

d. Exit the conference by disconnecting the call.

5. Verify the device is ready.

a. Configure this MCU in Equinox Management as explained in Administrator Guide for

Avaya Equinox Management.

b. Take other MCUs offline (if any) to make sure you hold the videoconference on this

MCU.

c. From an endpoint dial the IP address (or the Auto-Attendant number if configured).

d. Press 0 to create a new conference.

e. At the prompt, enter the meeting ID followed by #.

The MCU creates the videoconference. If it is successful, the MCU is properly installed

and configured.

You can view the videoconference status in these pages:

• The MCU's Status Map which shows the connection to Equinox Management and

conference use statistics.

• The Equinox Management Dashboard which shows the details of the current

videoconference.

f. Exit the videoconference by disconnecting the call.

Table of Contents