Avaya Scopia Elite 6000 MCU Series Rack Mounting Manual page 25

- Two flat-head short screws (Phillips cross recessed flat-head machine screws 6-32
UNCx3/16")
- Two flat-head long screws (Phillips cross recessed flat-head machine screws M5x12mm)
- Two brackets (finishing washers M5)
Figure 18: Preparing the parts required to mount the device onto the rails
Procedure
1. Attach the inner rail extension to the rear of the device:
a. Slide the rear inner rail extension towards the front of the device (see
Attaching inner rail extensions to the device
The hooks on the side of the device fasten the inner rail in place.
Figure 19: Attaching inner rail extensions to the device
b. Secure the rear inner rail extension through one of the two holes on the rail extension,
using one flat-headed short screw
page 26).
January 2017
(Figure 20: Securing rail extensions to the device
Rack Mounting Guide for Avaya Scopia Elite 6000 MCU
Comments on this document? infodev@avaya.com
Mounting the Device on to the Rack
on page 25).
Figure 19:
on
25