Avaya Scopia Elite 6000 MCU Series Rack Mounting Manual page 22

Setting up the Device
2. Attach the rails to the rack posts, at the location you marked:
a. Starting at the rear of the rack, attach the short rail by aligning the two square knobs
with the rack holes
page 22).
The rails are spring-loaded and lock into place on the rack with a safety latch.
b. Slide the long rail towards the front of the rack, adjusting the length according to the
depth of the rack. Attach it to the front of the rack as you did to the rear of the rack.
Important:
To unfasten the rail pins from the rack, push the safety latch to release:
January 2017
(Figure 14: Attaching the short rail to the rear of the rack
Figure 14: Attaching the short rail to the rear of the rack
Figure 15: Removing the rack from the rails
Rack Mounting Guide for Avaya Scopia Elite 6000 MCU
Comments on this document? infodev@avaya.com
on
22