Unpacking The Device - Avaya Scopia Elite 6000 MCU Series Rack Mounting Manual

Rack mounting preparation
• The device physical dimensions.
For more information, see
Ensure the site conforms to the listed requirements.

Unpacking the Device

About this task
We strongly recommend that you follow safety guidelines described in this section during unpacking.
Procedure
1. Inspect the shipping box to verify that it is not seriously damaged during shipping.
2. Place the shipping box on a horizontal surface paying attention to the This Side Up symbol
on the shipping box
Caution:
The accessories kit is situated on top of the device inside the shipping box and can be
damaged if the box is placed upside down. Pay attention to the This Side Up symbol on
the shipping box to handle the box correctly at all times.
Caution:
To prevent injury and equipment damage, follow the lifting guidelines described in the
Safety Guide when lifting or moving the shipping box.
3. Cut the plastic straps.
Caution:
The plastic straps are tightly stretched and can hit you when you cut them. To avoid this,
make sure you do not face the side of the box secured by the straps before you cut the
straps.
4. Cut the strapping tape.
5. Open the shipping box.
6. Take the accessories kit out of the shipping box.
7. Take the device out of the shipping box.
8. Carefully open the additional boxes, remove the packing material, and remove the drives
and other contents.
January 2017
Technical specifications
(Figure 1: This Side Up symbol
Figure 1: This Side Up symbol
Rack Mounting Guide for Avaya Scopia Elite 6000 MCU
Comments on this document? infodev@avaya.com
on page 8 to learn about these requirements.
on page 10).
10