Diagnostic Log - Siemens SITRANS F Series Operating Instructions Manual

Assign alarm class
Table A-93 Assign alarm class
Modbus Data type /
register Size in bytes
6328 Unsigned / 2
6329 Unsigned / 2
A.9.6.2

Diagnostic log

Table A-94 Diagnostic log
Modbus Data type /
register Size in bytes
6600 Unsigned / 2
6614 Unsigned / 2
6615 String / 16
10800 String / 32
6623 Unsigned / 2
SITRANS FST030 (Modbus)
Operating Instructions, 08/2018, A5E37367739-AD
Parameter Description
Transmitter Defines the mapping of
temp. too high this event to an alarm
class respective NA‐
MUR status signal.
Transmitter Defines the mapping of
temp. too low this event to an alarm
class respective NA‐
MUR status signal.
Parameter Description
Newest entry Entry number of new‐
number est entry. Older entries
have a smaller entry
number.
(Wrap around from 0 -
100).
Entry number Selection of the entry
number.
Time stamp Time stamp of the diag‐
nostic log entry speci‐
fied by Entry number.
Format is YYYY-MM-
DD hh-mm.
Time stamp Time stamp of the diag‐
nostic log entry speci‐
fied by Entry number.
Format is YYYY-MM-
DD hh-mm-ss.
State Alarm state of the entry
specified by Entry num‐
ber.
A.9 Modbus holding registers tables
Default value Value range /
[unit] Setting options
(unit register)
1
● 1: Process alarm
(PA) resp. Out of
specification.
● 4: Maintenance alarm
(MA) resp. Failure.
1 ● 1: Process alarm
(PA) resp. Out of
specification.
● 4: Maintenance alarm
(MA) resp. Failure.
Default value Value range /
[unit] Setting options
(unit register)
- -
0 0 - 100
- -
- -
- ● 0: Event is reset
(going).
● 1: Event is set
(coming).
● 2: Alarm is
acknowledged.
Modbus communication
Access
level
Read /
write
Read /
write
Access
level
Read
only
Read /
write
Read
only
Read
only
Read
only
291