Table of Contents
Advertisement
Unpacking the DSC 4000
The DSC 4000 System consists of the following components:
DSC 4000
•
•
Personal Computer
•
Pyris Software
•
Printer (optional)
Intracooler 6P (optional)
•
Portable Cooling Device (optional)
•
Chiller (optional)
•
•
Autosampler (optional)
The autosampler is an optional accessory that is used to automate the running of multiple
samples. It is factory installed. The sample tray holds up to 45 samples. Runs can be
sequenced and postrun data analyzed by using a play list which is created using the Pyris
Player software.
The DSC 4000 comes wrapped in plastic and is surrounded by foam on all sides of the
analyzer. The DSC 4000 weighs 17 kg (37 lb), or 19 kg (42 lb) with the autosampler
installed. To unpack the analyzer, follow the steps below:
1. Remove the foam inserts from the box.
2. Remove the analyzer from the box.
3. Remove the foam from all sides, turning the analyzer on end as necessary.
4. Remove the tape and plastic from around the analyzer.
5. Remove the tape from the outer furnace lid and remove the lid. Place it to the side.
6. Remove the packing material from inside the furnace area.
7. Remove the tape from the connectors on the rear of the instrument.
When unpacking each box of your shipment, check all the parts included against the shipping
list. If any part is damaged or missing, contact the delivery service and PerkinElmer
immediately.
The DSC 4000 is shipped with a Spares Kit. If you have purchased the AS 6000 Autosampler,
this is installed at the factory.
Install a DSC 4000 . 37
Advertisement
Table of Contents
