Table of Contents
Advertisement
Chapter 2: The Accu-Chek FastClix Lancing Device
Using the Accu-Chek FastClix Lancing Device
• The black cap is for fingertip testing only.
• Remember that the opening where the lancet comes out is not in the center of the cap.
• Remove the cap by pulling it straight off. Do not twist the cap.
• A new lancet drum is dark gray with a white end.
• A used lancet drum has a visible red stripe on the white end.
• You cannot reuse a used lancet drum.
• Do not remove the lancet drum until you have used all 6 lancets.
• The penetration depth indicator on the comfort dial shows the current depth setting.
The higher the number, the deeper the penetration. The best depth setting is the
lowest number that lets you get enough blood for a test. Try different depth settings to
find the one that is right for you.
• For soft skin, we suggest a depth setting of 2. For thick skin, try a higher depth setting.
1080_Guide Me_MANUAL_MASTER.indb 13
The Accu-Chek FastClix Lancing Device
2
13
3/5/2018 1:27:47 PM
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Guide Me and is the answer not in the manual?
Questions and answers
I have replaced batteries according to the instructions, have checked and recked batteries are in correct positions, now, nothing comes up on screen
The Accu-Chek Guide Me meter may not be turning on after replacing the batteries due to the following reasons:
1. Incorrect Battery Installation – Ensure that both CR2032 lithium batteries are inserted with the positive side facing up and properly positioned under the black tabs.
2. Loose Battery Door – The battery door must be securely snapped in place to hold the batteries correctly.
3. Old or Faulty Batteries – Make sure both batteries are new, from the same brand, and properly charged.
4. Damaged Battery Contacts – Check for any dirt or damage on the battery contacts inside the meter.
5. Meter Malfunction – If the issue persists, the meter may need to be reset or checked by customer support.
Try reinstalling the batteries correctly and ensuring the battery door is secure. If the problem continues, consider replacing the batteries again or contacting Accu-Chek Customer Care.
This answer is automatically generated
what is e-6
Does the Accu Chek Guide Me glucose monitor have a reminder alarm system
what is error 9
What is ERR code E-9
The E-9 error code on the Accu-Chek Guide Me may still appear after changing the batteries. If it does, remove the batteries again, press the power button for at least 2 seconds, then reinsert the batteries.
This answer is automatically generated