Start Date Prompt - GE DigitalFlow GC868 Programming Manual

STARTTIME Prompt (cont.)

START DATE Prompt

Procedure Options
Logging Data
[F1]-[F2]
a. Press to select
[ENT]
(1-12) and press
current time will generate an error message.)
b. Enter the desired Minutes and press
range is 0 to 59.
c. Enter the desired Seconds and press
range is 0 to 59.
[F1]
11. Press to accept the displayed Start Date or press
different start date. To start logging today, press
•
OK TODAY
If or was selected, you have finished setting up the
error log. Proceed to Procedure Options below.
•
Otherwise, complete the following steps to Edit the Start Date.
a. Enter the desired Year and press
0 to 99.
b. Use the [←], [→] and
Month.
c. Enter the desired Day and press
1 to the number of days in the selected month (28, 29, 30 or
31).
You have completed setting up the error log. Do one of the following:
•
Use [↑] and [↓] to review the previous menu prompts.
• [F1]-[F4]
Press to select one of the
•
To return to the data screen and begin logging data, press the
[ENT]
key. The * on the locator bar indicates that the Model
GC868 is now compiling the specified error log.
The error log will continue to run until it is manually stopped, the
meter runs out of memory (for a non-circular log), or the entire 120
records (2 pages x 60 records/page) have been logged.
AM PM
or . Then, enter the desired Hour
. (Entry of a start time earlier than the
[ENT]
. The acceptable
[ENT]
. The acceptable
[F3]
[ENT]
. The acceptable range is
[F1]-[F4]
keys to select the desired
[ENT]
. The acceptable range is
LOG
submenus.
April 2008
[F2]
to enter a
.
3-11