Start Date Prompt; End Time Prompt; End Date Prompt - GE DigitalFlow GC868 Programming Manual

April 2008
STARTTIME Prompt (cont.)

START DATE Prompt

END TIME Prompt

3-4
[F1]-[F2]
a. Press to select
[ENT]
(1-12) and press
current time will generate an error message.)
b. Enter the desired Minutes and press
range is 0 to 59.
c. Enter the desired Seconds and press
range is 0 to 59.
[F1]
11. Press to accept the displayed Start Date or press
different start date. To start logging today, press
•
OK TODAY
If or was selected, proceed to step 12 for a non-
circular log or to step 13 for a circular log.
•
Otherwise, complete the following steps to Edit the Start Date.
a. Enter the desired Year and press
0 to 99.
b. Use the [←], [→] and
Month.
c. Enter the desired Day and press
1 to the number of days in the selected month (28, 29, 30 or
31).
[F1]
12.Press to accept the displayed End Time or press
different end time. To select a specific time period for the log to
[F3]
run, press .
• OK
If was selected, proceed to the
•
TIMED
If was selected, proceed to the
• EDIT
If was selected, complete the steps on the next page.
Note: The log
END TIME
five minutes. Failure to observe this restriction will result in
an error message.
AM PM
or . Then, enter the desired Hour
. (Entry of a start time earlier than the
[ENT]
. The acceptable
[ENT]
. The acceptable
[ENT]
. The acceptable range is
[F1]-[F4]
keys to select the desired
[ENT]
. The acceptable range is
END DATE
LOG TIME
START TIME
must exceed the log
[F2]
to enter a
[F3]
.
[F2]
to enter a
prompt.
prompt.
by at least
Logging Data