Entering Volumetric Data; Entering Totalizer Data; Mass Flow (Static) - GE DigitalFlow GC868 Programming Manual

Entering Volumetric Data

Entering Totalizer Data

Mass Flow (static)?

Programming Site Data
[F1]-[F4]
8. Use the and [→] keys to select the desired Volumetric
Units for the flow rate display. The available volumetric and
totalizer units are shown in Figure A-1 on page A-1.
[F1]-[F4]
9. Use the keys to select the Volumetric Time (units for the
volumetric flow rate display).
[F1]-[F4]
10.Use the keys to select the Vol Decimal Digits (the desired
number of digits to the right of the decimal point) in the
volumetric flow rate display.
[F1]-[F4] and
11. Use the
[F1]-[F4]
12.Use the keys to select the Total Decimal Digits (the
desired number of digits to the right of the decimal point) in the
totalized flow display.
Static Density?
13.If the prompt in the
NO
is set to , the GC868 returns to the initial User Program screen.
Otherwise, proceed as follows:
[F1]-[F4]
a. Use the keys to select the Mass Flow units, listed in
Table 1-2 below.
Table 1-2: Available Mass Flow Units
English Mass Flow Units
LB- Pounds
KLB - Thousands of Pounds
MMLB - Millions of Pounds
TONS - Tons
[F1]-[F4]
b. Use the keys to select the Mass Flow Time units.
[F1]-[F4]
c. Use the keys to select the MDOT DECIMAL DIGITS
(the number of digits to the right of the decimal point) for
displaying mass flow.
[F1]-[F4]
d. Use the keys to select the Mass (Totalizer) units, listed
in Table 1-2 above.
[F1]-[F4]
e. Use the to specify the Mass Decimal Digits (the
number of digits to the right of the decimal point) for
displaying totalized mass flow. The meter returns to the initial
User (or Channel) Program screen.
[→] keys to select the Totalizer Units.
ADVAN
option (
Metric Mass Flow Units
KG - Kilograms
Tonnes - Metric Tons
April 2008
SETUP
submenu)
1-11