Log Type; Starttime Prompt - GE DigitalFlow GC868 Programming Manual

April 2008
Creating an ERROR Log
(cont.)

Log Type

STARTTIME Prompt

3-10
In addition, refer to Chapter 3, Diagnostics, of the Service Manual for
a discussion of the many parameters accessible via the
Note: The units assigned to the parameters in Table 3-2 on page 3-9
are those selected in the User Program (
6. Use the [←], [→] and
to be logged.
7. Use the [←], [→] and
be logged.
•
If you selected a totalized value for display, go to step 8.
•
If you did not, go to step 9.
8. At the Set Log Totals to 0 prompt, press
at their present value or press
YES
Choosing at this prompt only resets the log totals to zero and
has no effect on the meter totals.
[F1]
9. Press to create a non-circular log or press
circular log.
A non-circular log automatically stops when the meter runs out of
memory or the specified
continuously until manually stopped, but only the data from the most
recent log cycle is saved. At the start of each cycle, the oldest
recorded data is overwritten by the new data from the current cycle.
If data from one circular log cycle exceeds the meter's
memory capacity, the earliest logged data will be lost.
[F1]
10.Press to accept the displayed start time or press
different start time. To start logging immediately, press
•
OK
If was selected, proceed to step 11.
• NOW
If was selected, you have finished setting up the error log.
Proceed to Procedure Options on the next page.
• EDIT
If was selected, complete the steps listed on the next page.
SYSTM
[F1]-[F4]
keys to select the second parameter
[F1]-[F4]
keys to select the third parameter to
[F1]
to leave the log totals
[F2]
to reset the log totals to zero.
END TIME
is reached. A circular log runs
Caution!
DIAG
option.
submenu).
[F2]
to create a
[F2]
to enter a
[F3]
.
Logging Data