Saving Site Data - GE DigitalFlow GC868 Programming Manual

April 2008

Saving Site Data

1-48
The currently programmed site data may be stored in the Model
GC868's non-volatile memory by saving it as a site file. Up to ten site
file names, consisting of up to five characters each, may be stored at
any given time. While following the programming instructions, refer
to Figure A-3 on page A-3 of Appendix A, Menu Maps. Enter the
SAVE
submenu by pressing [→] and
screen and complete the following steps:
1. Enter a new site file name and press
[F1]-[F4]
keys to select and overwrite an existing site file.
Note: The option bar will show only as many choices as there are
existing site files.
If ten site files are already stored in memory, an existing site file must
be deleted before a new site file name can be assigned. See Chapter 5,
Clearing Data, for details.
When a site file is stored in memory, it becomes the active site file
until another site file is created or retrieved. (See the next section for
instructions on retrieving a site file.) To verify that the site file has
been saved, use the [↑] key to scroll back to the
and see if the name appears on the option bar (use the [←] and [→]
keys to scroll through the list, if necessary). Whenever a new site file
name is saved, it is automatically assigned to the next available
[EXIT]
function key. Press
2. Use the [←] and [→] and
[EXIT]
press to leave the User Program and return to measurement
mode.
[F4]
at the initial User Program
[ENT]
, or use the [←], [→] and
SITE NAME
SAVE
to leave the submenu.
[F1]-[F4]
keys to select another menu, or
Programming Site Data
prompt