Transducer Spacing - GE DigitalFlow GC868 Programming Manual

April 2008

Transducer Spacing

Procedure Options
1-16
11. The Transducer Spacing prompt displays the spacing of the
transducers, as calculated from the information you have entered.
Record this number in Appendix B, Data Records, and use it to
properly space the transducers.
Note: If necessary, you can overwrite the spacing shown at the
previous prompt (using the numeric keys) to match the actual
physical spacing of the transducers. GE does not recommend
overwriting the spacing. If you must, do not change the
spacing by more than ±10% from the value shown.
After completing the above steps, the meter returns to the User
Program prompt. Continue as follows:
•
To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of the manual for instructions.
•
To leave the User Program and retain the previous settings,
[EXIT]
press and then press
programming changes will be discarded and you will be
returned to the data display.
•
To leave the User Program and return to measurement mode,
[EXIT]
press and then press
programming changes will be entered into the meter's memory,
and you will be returned to the data display.
[F1] = NO
at the SAVE prompt. Any
[F2] = YES
at the SAVE prompt. Your
Programming Site Data