Recalling A Site - GE DigitalFlow GC868 Programming Manual

Recalling a Site

Programming Site Data
Any site file currently stored in the Model GC868's non-volatile
memory may be recalled at any time. Up to ten site file names,
consisting of up to five characters each, may be stored at any given
time. While following the programming instructions, see Figure A-3
on page A-3 of Appendix A, Menu Maps. Enter the
by pressing [→] twice and
complete the following steps:
1. Use the [←], [→] and
site file.
Note: The option bar shows only as many choices as there are
existing site files. The files are listed in chronological order by
creation date.
Upon recall, the selected site file becomes active and all of its
programmed parameters become current.
IMPORTANT:
CLOCK
The
file, while the
the site file.
Note: If you have loaded a site file into a GC868, but the option
cards are not in the same slots or programmed the same way
as when the site file was first saved, the GC868 displays a
warning to review slot information. This display does not
mean that the option cards have lost their program
information!
2. Use the [←] and [→] and
[EXIT]
press to leave the User Program and return to measurement
mode.
[F1]
at the initial User Program screen and
[F1]-[F4]
keys to select and recall an existing
I/O
and data is not recalled with the site
SYSTM COMM
and data is recalled with
[F1]-[F4]
keys to select another menu, or
April 2008
RECLL
submenu
1-49