Start Date Prompt; End Time Prompt; End Date Prompt - GE DigitalFlow GF868 Programming Manual

Chapter 3. Logging Data

3.2.3 START DATE Prompt

11. Press [F1] to accept the displayed Start Date or press
.
[F3]
•
If or was selected, proceed to step 12 for a non-circular log or to step 13 for a circular log.
OK TODAY
•
Otherwise, complete the following steps to Edit the Start Date.
a. Enter the desired Year and press
b. Use the [, [ and
c. Enter the desired Day and press
(28, 29, 30 or 31).

3.2.4 END TIME Prompt

12. Press to accept the displayed End Time or press
[F1]
period for the log to run, press
•
If was selected, proceed to the
OK
•
If was selected, proceed to the
TIMED
•
If was selected, complete the steps on the next page.
EDIT
Note: The log
END TIME
result in an error message.
a. Press to select
[F1]-[F2]
earlier than the current time will generate an error message.)
b. Enter the desired Minutes and press
c. Enter the desired Seconds and press

3.2.5 END DATE Prompt

13. Press to accept the displayed end date or press
[F1]
•
If or was selected, proceed to the
OK TODAY
diagram of the programming sequences.
•
Otherwise, complete the steps below.
a. Enter the desired Year and press
b. Use the [, [ and
c. Enter the desired Day and press
(28, 29, 30 or 31). The program proceeds to step 15.
52
. The acceptable range is 0 to 99.
[ENT]
keys to select the desired Month.
[F1]-[F4]
[ENT] . The acceptable range is 1 to the number of days in the selected month
.
[F3]
END DATE
LOG TIME
must exceed the log
START TIME
or . Then, enter the desired Hour (1-12) and press
AM PM
[ENT]
[ENT]
. The acceptable range is 0 to 99.
[ENT]
keys to select the desired Month.
[F1]-[F4]
. The acceptable range is 1 to the number of days in the selected month
[ENT]
[F2] to enter a different start date. To start logging today, press
to enter a different end time. To select a specific time
[F2]
prompt.
prompt.
by at least five minutes. Failure to observe this restriction will
. The acceptable range is 0 to 59.
. The acceptable range is 0 to 59.
to enter a different end date. To end the log today, press
[F2]
prompt. Refer to Figure 16 on page 92 for a flow
TIME INCREMENT
DigitalFlow™ GF868 Programming Manual (1-Channel)
. (Entry of a start time
[ENT]
.
[F3]