Linde 350 Series Service Training page 73

Service Training
WINDOW 3 STORED FAULT MESSAGES
Window (3) displays all the fault messages stored in the EEPROM. The frequency of each fault is indicated
to the right of a colon behind the fault number. The fault counter can only count to 9 maximum.
These fault messages are stored permanently independent of turning the ignition on and off.
Fault number
The fault codes have the following meaning:
Fault messages:
The following reactions can occur on the truck with individual faults:
W Warning lamp flashing
K Truck driving at creep speed
B Truck brakes to a full stop or remains stationary when not moving
R Current achieves only start of pump control
E All power stages are without power
L engine goes to low idling speed
F Release magnet de-energised, truck braking with brake jets (restrictors)
S Safety relay in the controller de-energised, all power stages without power
20 Invalid truck code
21 Invalid engine type code
22 Invalid series code
23 Invalid Series/special truck code
31 Accelerator pedal: pot 1B2.1 and pot 1B2.2
32 Accelerator pedal: signal from pot 1B2.1
33 Accelerator pedal: signal from pot 1B2.2
34 Accelerator pedal: pot supply voltage
35 1-/2-pedal: invalid combination of direction signals
Fault frequency
02.01
Reactions on the truck
maybe cable loom
maybe cable loom
maybe cable loom
maybe cable loom
incompatible
out of range
out of range
too low
Section 2
Page 47
WELFS
WELFS
WELFS
WELFS
WBL
WBL
WBL
WBL