Linde 350 Series Service Training page 166

Section 2
Page 140
A
The brake of the turning
wheel is not in order.
Remove and remedy the
fault.
Seal at right-hand brake
piston defective.
02.01
Plug port BR at the brake valve. Start the engine, release the brake, fully depress
the F or R pedal.
yes
Drive wheels rotate.
Remove test fitting at port BR and connect low pressure gauge (without brake
line) to port BR at the brake valve. Measure the pressure with the engine running
and the brakes released.
yes
Pressure min. 17.5 bar.
Remove test fitting and reconnect low pressure gauge to port BR (with brake
line). Plug port BR of right brake with banjo screw with cap. Measure the pressure
with the engine running and the brakes released.
yes
Pressure min. 17.5 bar.
Service Training
no
Braking system in order.
no
Brake valve defective. Repair
or replace valve.
no
Seal at left-hand brake piston
defective.
B