Linde 350 Series Service Training page 70

Section 2
Page 44
WINDOW 2 CURRENT STATUS MESSAGES AND FAULT MESSAGES
This window displays a message if driving is restricted or disabled for safety reasons. The messages are
displayed only as long as the restriction or problem exists. In case of faults the red warning lamp will flash;
in case of wrong driver commands such as depressing the brake pedal, the lamp will not illuminate.
The current truck status messages are displayed as a single-digit number, the fault message as a two-digit
number.
In the above example, brake switch 1 and 2 are operated, i.e. the engine can be started. Error 31 was
detected, i.e. potentiometers 1 and 2 are incompatible. When the brake pedal is released, the numbers 1
and 2 will disappear, whereas the fault number 31 will still be displayed. The engine can be therefore be
started, but the truck will not move off if an accelerator pedal is operated.
The meaning of the status and error numbers are listed in the following table.
The fault codes have the following meaning:
Status messages:
If none of the following status messages are shown in window 2, the
truck is operational if no other fault has been detected in the truck.
1 Brake pedal switch 1S5 operated (brake pedal is partially depressed)
2 Brake pedal switch S14 operated (brake pedal is depressed)
3 Brake pedal not yet depressed after turning on the ignition
4 Seat switch not operated
02.01
Example: (31) = Potentiometers 1 and 2 are incompatible
Example: 1 = Brake switch 1 operated
Example: 2 = Brake switch 2 operated
Service Training