Linde 350 Series Service Training page 12

Section 1
Page 6
- Remove securing bolts (2) from bracket (3 bolts).
- Remove securing bolt (1) from rear support bracket.
NOTE: Loosen the lower and right-hand securing bolt
from the front.
ATTENTION
Under no circumstances should the securing
bolts (see arrows) holding the fuel injection pump
head be loosened.
Loosening the securing bolts would allow the
head to move and would cause the breakage of
the distributor plunger.
INSTALLATION
- Install the fuel injection pump and align centrally in the
elongated flange holes.
Tightening torques:
Pump mounting bolts:
Fuel pipes:
Injection pump sprocket:
ATTENTION
Do not interchange the feed and return pipe banjo
bolts. The inside diameter of the bolt for the return
pipe is smaller and the hexagon head is marked
"OUT".
- Install injection pump sprocket and fix position with
positioning pin (2064).
- Loosen bolt of camshaft sprocket by half a turn. Free
camshaft sprocket from the taper by tapping with a
hammer (using a drift through the hole in the rear toothed
belt guard).
- Check that TDC mark on the flywheel is aligned with the
reference mark
- Install toothed belt and remove the positioning pin from
the fuel injection pump sprocket.
25 Nm
25 Nm
45 Nm
Service Training