Linde 350 Series Service Training page 119

Service Training
WINDOW 7 SETTING TRUCK SPEED AND SPECIFIED RPM
This window displays the parameters specified by the controller. These parameters can be modified up
to certain limits.
Maximum speed in km/h
Engine RPM
swashplate angle in %
HOW TO CHANGE THE PARAMETERS
- Press the ENTER button.
- The cursor will appear and jump to the first parameter.
- The value can be changed within limits using the "+" and "-" buttons.
- The modification is stored instantly and is in effect.
- Go to the next parameter by pressing ENTER again.
- The entry of parameters can be ended by selecting a different window number.
NOTE: V can only be modified by changing n
max
The speed is changed in steps of 50 RPM.
A change of n
depressed.
The speed of n1S1 and n1S2 can be changed in steps of 100 RPM.
WINDOW 71 RESETTING PARAMETERS TO STANDARD FACTORY SETTINGS
Pressing 71 (7 and 1) quickly displays window 71 (sub-window of 7).
In window 71 the parameters shown in window 7 can be reset to their factory default settings.
The parameters are reset to their factory default settings by pressing the CE key.
is only effective if the brake pedal is released and the accelerator pedal fully
max
02.01
Tilting RPM, switch 6 bar
Lifting RPM, switch 14 bar
Auxiliary hydraulics RPM
(option)
(engine RPM) or g
max max
Section
Page
(pump swashplate angle).
2
93