Linde 350 Series Service Training page 227

Service Training
CHECKING THE SPEED LIMITER
Check the resistance at the speed limiter contacts.
Specified value: 4 - 6 kW.
If the specified value is not obtained: renew the speed limiter.
CHECKING THE STALL SPEED
- Disconnect the lift magnet linkage.
- Read the stall speed at the speed limiter.
- Start the engine and increase the engine speed until the
speed limiter begins to limit the speed.
- Compare the stall speed with the speed reading (± 100 rpm),
replacing the speed limiter if necessary.
Section 9
Page 19