Linde 350 Series Service Training page 226

Section 9
Service Training
Page 18
9.2.1.5.2 HALL GENERATOR
TEST REQUIREMENTS
- TSZ-H switch unit must be in order.
- Ignition coil must be in order.
- Lead and connections between the TSZ-H switch unit and the distributor must be in order.
- Connectors and the attaching parts at the distributor, Hall generator and TSZ-H must be in order.
TEST
- Pull the high voltage lead terminal 4 out of the distributor and earth it with the aid of another cable.
- Remove the rubber boot on TSZ-H switch unit connector. The plug remains connected.
- Connect the voltmeter between pins 6 and 3.
- Switch on the ignition.
- Slowly crank the engine by hand in the normal direction of rotation and watch the voltmeter.
Desired value: Voltage alternates between 0 and 2 V minimum. If not, replace the Hall generator.