Linde 350 Series Service Training page 133

Service Training
WINDOW 3 STORED FAULT MESSAGES (DISPLAY AND DELETE FUNCTION)
Window (3) displays all the fault messages stored in the EEPROM. The frequency of each fault is indicated
to the right of a colon behind the fault number. The fault counter can only count to 9 maximum.
These fault messages are stored permanently independent of turning the ignition on and off.
In this window the displayed errors can be cleared after pressing the "CE" key. Simultaneously a slash
"/" will appear behind the last error displayed in window 31.
Fault number
The fault codes have the following meaning:
Fault messages:
The following reactions can occur on the truck with individual faults:
W Warning lamp flashing
K Truck driving at creep speed
B Truck brakes to a full stop or remains stationary when not moving
R Current achieves only start of pump control
E All power stages are without power
L engine goes to low idling speed
F Release magnet de-energised, truck braking with brake jets (restrictors)
S Safety relay in the controller de-energised, all power stages without power
Test conditions:
Battery min. 11.3 V
Potentiometer calibration --> window 8
NOTE: If no calibration is possible, there may be a problem with the pedal mechanism in addition to
a defective potentiometer.
Fault frequency
Section
02.01
Page
2
107