D-3.14 Adjusting The Sensor Distance - Genie GTH-3512 Operator's Manual

D-3.14 ADJUSTING THE SENSOR DISTANCE

■
In case of a failure or complete malfunctioning of the sensors due to
a loosening of their fixing ring nuts, re-adjust their position:
1 Loosen nuts A fixing sensor B.
2 Set the mobile part C of the machine, controlled by the sensor,
as close as possible to it.
Move the sensor near the component until the LED indicator D
lights up.
3
Move the sensor 1÷2 mm nearer. Smoothly tighten the sensor
fixing nut and the relevant lock nut.
One proximity sensor is installed on the machine:
N° 1 proximity sensor disabling the use of the outriggers when
the boom is raised more than 2 metres above the ground
SERVICE INTERVAL
Running-in ____________________________ None
Ordinary ___________________ When necessary
Handler with telescopic boom GTH-3512
MAINTENANCE
D - 17
Page
Document 57.0008.7200 - 05/2007
1 2 mm
÷
Courtesy of Crane.Market