C-2.2 Adjusting The Seat; C-2.3 Fastening The Seat Belts - Genie GTH-3512 Operator's Manual

■ C-2.2 ADJUSTING THE SEAT

Position the seat so you can comfotarbly reach all the
controls. The handler seat is fitted with devices which
let you adjust the seat springing, height and distance
from the controls, the backrest angle and the armrest
height.
• Adjusting the seat distance from the controls
To slide the seat forward or back, rotate lever A
and push the seat to the desired direction. Then
release the bar and make sure that the seat locks
in position.
• Adjusting seat height and springing
Free the lever of knob B and turn clockwise or
counter-clockwise until reaching the desired
springing. Once you'are correctly seated in the seat
check that the yellow indicator C is in the green
field.
• Adjusting the backrest angle
Operate lever D, press your back firmly against the
backrest and put the backrest at the angle you
wish, then release the lever.
• Adjusting the armrest height
Raise armrest E and turn wheel F to put the armrest
at the height you want.
DANGER
• The seat is for one person only.
• Don't adjust the seat when the machine is
moving.
Handler with telescopic boom GTH-3512
OPERATING INSTRUCTIONS
■ C-2.3
Sit correctly in the driving seat; then:
• The safety belts are equipped with reel retractor.
To fasten the belt, pull tab 1 and push it into buckle
2.
To release the belt, push button 3 and remove the
•
tab from the buckle.
• Make sure that the buckle is correctly located at
the hip point and not on the stomach.
• Operate the end adjusters to reach the length you
wish and make sure the buckle is always in the
middle.
C - 4
Page
Document 57.0008.7200 - 05/2007
FASTENING THE SEAT BELTS
Courtesy of Crane.Market