Genie GTH-3512 Operator's Manual page 110

PROBLEM
THE BOOM DOES NOT MOVE
CHECKING THE MICRO-
SWITCHES WHEN THE DLE IS IN
ALARM, THE BOOM IN/OUT
MOVEMENTS, THE OUTRIGGER
UP-MOVEMENT AND
MACHINE SWAY FUNCTION
REMAIN ACTIVATED
CHECKING THE MICRO-
SWITCHES WITH THE BOOM
RAISED 2 METRES ABOVE THE
GROUND THE OUTRIGGER UP-
MOVEMENT AND THE MACHINE
SWAY FUNCTION REMAIN
ACTIVATED
THE DLE MOMENT LIMITING
SYSTEM IS IN ALARM
ALARM MESSAGES OF THE DLE
MOMENT LIMITING SYSTEM
SHOWN ON THE DISPLAY
Handler with telescopic boom GTH-3512
PROBLEMS AND TROUBLESHOOTING
CAUSES
• Fuse blown (F19 - 10 A)
• "ROAD/JOBSITE" switch set to
"ROAD"
• Check that the connectors are
correctly plugged in the actuator
THE
• Check that the connectors are
correctly plugged in the actuator
• Fuse blown (F25 - 10 A)
• System fault
1 E2PROM error
2 Value read from CELL 1 higher than
the maximum permissible
3 Value read from CELL 2 higher than
the maximum permissible
Page
Document 57.0008.7200 - 05/2007
• Check the fuse and replace if
necessary
• Switch to "JOBSITE"
• If the connectors are plugged in
correctly, contact the GENIE
Technical Assistance.
• If the connectors are plugged in
correctly, contact the GENIE
Technical Assistance.
• Check the fuse and replace if
necessary.
• Turn power off and on and RESET
the system. If the error message is
still shown, contact GENIE to re-
calibrate the unit.
• Check the wiring between control
panel and load cell
• Check that the load cell is fixed
correctly
• Check the connecting cable or the
connectors is/are not shorted
• If the error message is still shown,
contact the GENIE Service Centre and
have the load cell be checked.
• Check the wiring between control
panel and load cell
• Check that the load cell is fixed
correctly
• Check the connecting cable or the
connectors is/are not shorted
• If the error message is still shown,
contact the GENIE Service Centre and
have the load cell be checked.
E - 4
SOLUTIONS
Courtesy of Crane.Market