Genie GTH-3512 Operator's Manual page 108

Table of Contents

Advertisement

E-1
FAULTS AND TROUBLESHOOTING
This chapter represents a practical guide for the
operator for fixing the most common failures and, at
the same time, detecting those interventions that must
be carried out by qualified technical engineers.
If you are unsure about anything, do not carry out
operations on the machine, but call in a skilled
technician.
E-1.1 Problems - Causes - Solutions
PROBLEM
THE DASHBOARD DOES NOT
TURN ON
THE ENGINE DOES NOT START
The starter does not run
THE ENGINE DOES NOT START
The starter runs, but the
engine does not start
THE MACHINE DOES NOT
MOVE
Handler with telescopic boom GTH-3512
PROBLEMS AND TROUBLESHOOTING
Any repair work, maintenance or troubleshooting
must be carried out with machine stopped, boom
in rest position or laid on the ground, parking brake
engaged and ignition key removed.
CAUSES
• Battery disconnected
• Battery down
• Fuse blown (F2G - 50 A)
• Forward/reverse gear selector not in
neutral position
• Battery down
• Battery cut-out switch ON
• Ignition board defective
• Solenoid valve (Y00)
• No fuel
• Fuel filter clogged
• Fuel hose empty (fuel used up)
• Starting motor defective
• Changeover switch in neutral
• Parking brake engaged
• Fuse blown (F14)
• Outrigger limit switch activated
• Drive system pump defective
E - 2
Page
Document 57.0008.7200 - 05/2007
DANGER
SOLUTIONS
• Connect the battery using the
relevant switch
• Recharge or replace the battery
• Check the main fuse in the engine
compartment and replace if
necessary
• Set the switch to 0
• Recharge or replace the battery
• Disconnect the battery
• Check and replace if necessary
• Check the power supply of solenoid
valve Y00
• Refuel
• See engine operator handbook
• Refuel, then refer to engine operator
handbook
• Check and replace if necessary
• Set the gear switch to correct
position
• Disengage
• Check the fuse and replace if
necessary
• Check the efficiency of the outrigger
limit switches and replace if
necessary
• Check the efficiency of the control
spools and replace if necessary
Courtesy of Crane.Market

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents