Genie GTH-3512 Operator's Manual page 102

Engine compartment fuses and relays
■
Ref. Amp. Circuit
F2G
50 MAIN FUSE
F3G
50 FUSE - GLOW PLUGS
K01
RELAY - START-UP
K02
RELAY - GLOW PLUG LED
K03
RELAY - PRE-HEATING
■ Relays
Ref. Circuit
K1 RELAY - HIGH BEAM
K2 RELAY - LOW BEAM
K3 RELAY - HORN
K4 RELAY - WORK LIGHTS
K5 RELAY - 1 st and 2 nd
K6 RELAY - NOT USED
K7 RELAY - FORWARD SPEED
K8 RELAY - REVERSE SPEED
K9 RELAY - TRANSMISSION DISCONNECTED
K10 RELAY - TRANSMISSION DISCONNECTED
K11 RELAY - START-UP ENABLING COMMAND
K12 RELAY - NOT USED
K13 RELAY - NOT USED
K14 RELAY - OUTRIGGERS
K15 RELAY - NOT USED
K16 RELAY - NOT USED
K17 RELAY - NOT USED
K18 RELAY - OPTIONAL
K19 RELAY - BLOCKED FORKS
K20 RELAY - NOT USED
K21 RELAY - POWER SUPPLY ACTIVATION FROM
PLATFORM (only with man-platform)
K22 RELAY - NOT USED
K23 INTERMITTENCE
K24 MODULE - STOPPED SHAFT
K26 SAFETY RELAY - ATTACHMENT COUPLING
Handler with telescopic boom GTH-3512
MAINTENANCE
MECHANICAL SPEED
Page
Document 57.0008.7200 - 05/2007
F3G
K03
K02
K23
K19
K24
K18
K16 K15 K17
K8 K5
K6
K7 K1 K11 K7
K12 K20
K10 K9 K21
K13
K2 K4 K3 K14
F6 F12 F15 F21 F27
F5 F11 F14 F20 F26
F4 F10 F13 F19 F25
K22
F3 F9 F18 F24
F2 F8 F17 F23
F1 F7 F16 F22
J3
J2 J1
ATTENTION
• Do not use fuses having a higher amperage
than that recommended, since they can
damage the electric system seriously.
• If the fuse blows after a short time, look for the
fault source by checking the electric system.
• Always keep some spare fuses for an
emergency.
• Never try to repair or short blown fuses.
• Make sure the contacts of fuses and fuse-
sockets ensure a good electric connection and
are not oxidised.
D - 26
F2G K01
K26
Courtesy of Crane.Market