Version with mechanical locking
To change an attachment, operate as follows:
•
Drive to the place where you will release the
mounted attachment (when possible, a solid and
sheltered site).
•
Disconnect the quick connectors of the attachment
(if any).
Pull out pin B locking the attachment after removing
•
the safety split-pin at its end.
•
Rest the attachment flat on the ground.
•
Pitch the attachment holding frame forward and
lower the boom to release the attachment upper
lock.
•
Move back with the machine and drive to the new
attachment to be coupled.
•
Hold the frame pitched forward and hook the
upper lock of the new attachment.
•
Retract and raise the attachment some
centimetres. It will centre automatically on the
quick coupling frame.
Refit pin B fixing it with its safety split-pin.
•
•
Re-couple the connectors of the attachment (if
any).
Handler with telescopic boom GTH-3512
OPERATING INSTRUCTIONS
After substitution, visually check the attachment is
correctly coupled to the boom, before operating
the machine. A wrongly coupled attachment may
result in damage to persons or things.
C - 33
Page
Document 57.0008.7200 - 05/2007
CAUTION
Courtesy of Crane.Market