C-3.2.6 Steering Mode Selection; C-3.2.7 Road/Jobsite Switch; C-3.2.8 Mechanical Gearbox Controls - Genie GTH-3512 Operator's Manual

■ C-3.2.6 Steering mode selection
Steering mode switch
Three-position switch for the selection
0
1 2
of the steering mode:
1 Crab steering
0 Two-wheel steering
2 Four-wheel steering
13
Handler with telescopic boom GTH-3512
OPERATING INSTRUCTIONS

■ C-3.2.7 Road/Jobsite switch -

Each pressure switches the selector from the Road
position to the Jobsite position.
In Jobsite mode:
•
In Road transfer mode:
•
•
Switch from the Road position to the Jobsite
position only when the machine stands still and the
wheels are straight in order not to lose proper
shafting alignment. If the wheels must be aligned,
consult chapter
Maintenance section.
■ C-3.2.8
29
11
Do not change mechanical gear when the machine
is running.
When a gear is not correctly put, the warning light
8.10 comes on
C - 11
Page
Document 57.0008.7200 - 05/2007
Switch has two positions:
1 The switch is on and the jobsite mode
is enabled.
2 The switch is off and the machine is
set to road transfer mode.
all the machine functions are enabled.
the boom movement is disabled
only the two-wheel steering mode is enabled.
ATTENTION
D.3-13 Shafting alignment
Mechanical gearbox controls
Mechanical gearbox pushbutton
For changing between 1
gear.
Push the button to select the
required speed.
Each pressure corresponds to the
selection of a new speed and the light
under the glass corresponding to the
selected speed lights up.
ATTENTION
IMPORTANT
(see C-3.3.2).
in the
st nd
and 2
Courtesy of Crane.Market