Oil Level In The (Front/Rear) Wheel Reduction Gears; D-3.12 Oil Level In The Power Divider - Genie GTH-3512 Operator's Manual

D-3.11 OIL LEVEL IN THE (front/rear) WHEEL
■
REDUCTION GEARS
To check the oil level within the wheel reduction gears:
• Stop the machine on a level ground and ensure the
parking brake is engaged and plug
horizontal axis.
• Clean the plug all around, then remove it and check
if oil is level with the hole.
• If necessary, add new oil through hole
level.
• Refit the plug.
For the oil change:
• Stop the machine and ensure the plug is oriented
along the vertical axis.
• Place a container of suitable size under the reduction
gear plug.
• Unscrew plug and drain any oil from the reduction
gear.
• Rotate the wheel by 90° until the plug finds again
on the horizontal axis.
• Add new oil through hole
• Refit and tighten plug
SERVICE INTERVAL
Running-in _________ Within the first
Ordinary __________________ Every
Handler with telescopic boom GTH-3512
MAINTENANCE
finds on the
until it is
.
.
10
hours
250
hours
Page
Document 57.0008.7200 - 05/2007

D-3.12 OIL LEVEL IN THE POWER DIVIDER

■
To check the oil level in the power divider:
• Stop the machine on a level ground and make sure
the parking brake is engaged.
• Clean level plug
• Remove the plug and check if oil is level with the
hole.
• When necessary, add new oil through plug
it is level with the hole.
• Refit and tighten the plug.
To change the oil:
• Place a container of suitable size under the drain
plug.
• Remove the level plug
• Remove the drain plug
• Refit and tighten the drain plug
• Add new oil through the filler until it is level with hole
.
• Refit and tighten filler/level plug
SERVICE INTERVAL
Running-in _________ Within the first
Ordinary __________________ Every
D - 15
all around.
and the filler.
and empty the gearbox.
.
.
10
hours
250
hours
Courtesy of Crane.Market
until