Changing The Optional Attachment - Genie GTH-3512 Operator's Manual

■ C-5.4 CHANGING THE ATTACHMENT
ATTENTION
Use only attachments directly manufactured or
recommended by GENIE and detailed in the
"Optional attachments" section.
Version with hydraulic locking (optional)
To change an attachment, operate as follows:
• Drive to the place where you will release the
mounted attachment (when possible, a solid and
sheltered site).
• Disconnect the quick connectors of the attachment
(if any), and connect the hydraulic locking pipes of
the attachments to couplings A.
• Rest the attachment flat on the ground.
• Free the attachment operating the control of the
attachment locking/unlocking cylinder
• Pitch the attachment holding frame forward and
lower the boom to release the attachment upper
lock.
• Move back with the machine and drive to the new
attachment to be coupled.
• Hold the frame pitched forward and hook the
upper lock of the new attachment.
• Retract and raise the attachment some
centimetres. It will centre automatically on the
quick coupling frame.
• Operate the (optional) control lever to lock the
attachment.
• Couple the connectors of the attachment, if any,
to the quick couplings of the frame.
Handler with telescopic boom GTH-3512
OPERATING INSTRUCTIONS
After substitution, visually check the attachment is
correctly coupled to the boom, before operating
the machine. A wrongly coupled attachment may
result in damage to persons or things.
C - 32
Page
Document 57.0008.7200 - 05/2007
CAUTION
Courtesy of Crane.Market